Analysis of the classification of plaster mold

Analysis of the classification of plaster mold

The plaster mold is specially designed for the production of gypsum products, such as gypsum line and gypsum line manufacturer.

The classifications of plaster mould are as follows:

Latex mold

It is usually used to manufacture standard products that need high quality, and the technology of manufacture is expensive and the price of its own latex is high. The most important thing is that the service life is not long enough, and it is not suitable for batch making of plaster. If it is a plaster painting, especially the brotherhood like white embryo, it is not suitable to use the latex mold. Usually, latex is the 20% mold of soft and hard, so it is often used to produce gypsum images, such as educational mold, medium and large scale landscape sculpture, etc., which are relatively large and not mass produced.

Rubber mold for plaster mold

The most commonly used mold for plaster painting is its application in plaster, coloured and wholesale gypsum, because of its low price, simple and simple manufacturing technology, easy demoulding and so on. As long as it is avoided in the sun, the service life can reach more than 1000 times. By so soft film, so it is not suitable to make the standard too large plaster like, such as (60 centimeters).

Plastic mould for plaster mold

First used to do cartoon type, because of fast production, low cost, and other advantages, very low end needs of the people.

Silica gel mold for plaster mold

The deformation is very small, but the cost is high. It is usually used to imitate commodities. The silica gel is high temperature resistant to about 160 degrees or even higher. Silica gel is not good enough to resist tear and pull.