Manufacturers maintenance mode for plaster line

Manufacturer's maintenance mode for plaster line

Those who install gypsum line manufacturers for many years the gypsum line, 10 to 20 years of that, we can use the 15CC mixing ammonia added 1000CC soap water, then clean with a soft brush or soft cloth gently washed clean after a few minutes, rinse with water can be.

Through the above introduction, believe in performance advantages for gypsum line machines have a certain understanding, in addition, in the production of gypsum line, for the size must be a clear understanding, in order to avoid the waste of materials, in addition, gypsum line came out in the production, but also pay attention to maintenance method, so as to better protect the gypsum line.

If the gypsum line installed not long or do not pay attention to accidentally stained with the stain, manufacturers can do the gypsum line: first for a little bit of stains, use a knife to gently scrape the surface layer; but if it is stained with ink, and deep penetration, will ink at digging, gypsum then the well mixed slurry filling, to be dried, with fine sandpaper draw; but filling gypsum and gypsum raw tone is not the same, will affect the appearance, so we can put the whole plaster line from the new paint, it will be white again the gypsum line (PS: the best step looking for experienced workers to operate).

Gypsum plaster line line manufacturers introduced European classical style decoration with classical and white color beauty, a long time will certainly be dust, dust in the treatment of gypsum line with the time, should use clean duster or soft brush gently brushing, or with a clean soft cotton cloth, special attention is paid to can not use wet cloth to wipe, wipe the dirty or more. But if you buy the gypsum line quality is not good. Maybe this method may not work, so we must not covet cheap in order to save a few bucks just to buy the inferior gypsum line, last a long time or even ahead of aging effect to new from the wall and ceiling decoration.